Details
A series of corners and offsets demonstrating the flexibility of a plywood system. This particular pictures illustrates the barn door hinge.
A outside wall of Gates Horizontal Rod system showing the top 2x4 waler, 5/8" walers in place engaging ties, and Gates staging bracket. The form is braced to the outside bank.
A close up of the staging and 5/8" engaged rods. Notice the rods breaking in the middle of a panel between the two ties.
Low wall 32" x 4' panels
A close-up of the Gates Horizontal Rod staging bracket. It is a single plank bracket used without a handrail at no higher than 60" off grade.
This detail shows a 8" plastic Gates Rebar Hanger. The plastic comes only in the 8". Notice the two slots for a "snap in" rebar application. Gates also manufactures a steel rebar hanger in the 8",10",12" sizes.
Gates Horizontal Rod system EZBB ties
- 4" through 36"
- Galvanized twisted 11 ga. tie CB ties
- Available 8",9",10",12"
- Black wire welded tie
- Crisp breakback
Hinged outside and inside corners
- Continuous hinge
- Barn door hinge
- Strap hinge utilizing a 5/8" cane rod
Left to Right, Top to Bottom
- 17" Angular Tie Cutter
- Chisel End Tie Cutter - 6' & 8'
- Clean Out Tool
- Gates Rod Tie Cutter
Additional Information
Manufacturer: Gates and Sons, Inc.
For More Information on the Horizontal Rod System for Residential Forming Features,
[Click Here] to Link to Manufacturer Web Site